Eap225-Outdoor disconnect mesh after channel switch

Benjamin_Werner

2024-10-05 05:33:32 - last edited 2024-10-16 02:15:59

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-10-05

Eap225-Outdoor disconnect mesh after channel switch

2024-10-05 05:33:32 - last edited 2024-10-16 02:15:59

Model: EAP225-Outdoor EAP245 OC200

Hardware Version:

Firmware Version:

Hello,

I have installed 2 Eap225-Outdoor and connect them via mesh with my eap245. It works very well until the eap245 changes the wifi channel to 40 because of detecting radar on channel 104. Then the eap225outdoor doesn't reconnect an are not reachable. Only a restart of the eap225outdoor works so they search for the eap245.

Is there a way to force the eap225outdoor to try to reconnect after he lost the mesh partner?

Or is there another way to fix this problem?

The setup is Router--cable--eap245--wifi--ep225outdoor--wifi--eap225outdoor

Thanks

Best regards

Benjamin

1 Accepted Solution

MR.S

LV5

2024-10-05 11:43:02 - last edited 2024-10-16 02:15:59

Posts: 2150

Helpful: 775

Solutions: 274

Stories: 0

Registered: 2018-08-17

Re:Eap225-Outdoor disconnect mesh after channel switch-Solution

2024-10-05 11:43:02 - last edited 2024-10-16 02:15:59

@Benjamin_Werner

if you have enabled channel limit, EAP225-Outdoor will not be able to mesh with anything below ch100, you should also enable Full-Sector DFS

Recommended Solution

Benjamin_Werner

LV1

2024-10-05 12:01:00

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-10-05

Re:Eap225-Outdoor disconnect mesh after channel switch

2024-10-05 12:01:00

@MR.S

As far as I remember, I have not set a channel limit. (but did I don't need a channel limit for outdoor usage in Germany?) Where can I see the settings?

Full dfs is active.