Devices connected to easy managed switch does not get IP assigned by router
Hi everyone,
Hoping someone can point me (a beginner) in the right direction!
I have a basic setup with a R7406 gateway, ES205GP switch, and a single EAP670 AP powered through the switch. A connected windows computer is running the controller software with all devices adopted.
I want to use the spare ports on the switch to connect a couple of clients, but when I connect a client to a port on the switch it does not get an IP issued, only clients connected directly to the gateway do.
What have I done wrong with my configuration?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I found the same problem, it works now :-) but it should be possible to enable All for easy managed switch
- Copy Link
- Report Inappropriate Content
@ all
The problem is the missing "all" Profiles for Easy-Managed Switches.
We need to manually create port profles and apply them (to the uplink ports too).
- Copy Link
- Report Inappropriate Content
Hi @aksw127
Thanks for posting in our business forum.
You probably need to wait for a while before you see they are synced to the controller.
They should be working I think. The switch syncs to the controller about their IPs. Note that the sync between devices to the controller on data like stats is not instant.
- Copy Link
- Report Inappropriate Content
i ordered a pair of ES205GP v1.0 and have a similar problem, default lan works but none of my vlan (tagged and untagged). i have enabled Easy Managed Switch on all vlan, controller is Windows 5.15.6.4 Beta
Firmware Version ES205GP v1.0 1.0.1 Build 20240801 Rel.41455
Everything looks right but it doesn't work, Are there any more places to configure?
I have also tested firmware Version 1.0.0 Build 20240721 Rel.42902 with same result.
In stand alone is vlan ok, no problem.
- Copy Link
- Report Inappropriate Content
I was just going through the same pain. In looking through various configs, I noticed the uplink/downlink port profile setting on all the other switches use 'All' but that is not a selectable profile on the ES205G and ES205GP.
I managed to get things working by creating a profile 'All_VLANs' and adding all the tagged networks to it then selecting it for the uplink port on the two switches.
Devices are now getting addresses from my dhcp server (opnsense firewall) but the address is not being seen on the client list on the controller.
Given the firmware for the ES205G is v1.0.1 and the ES205GO is v1.0.0 I'm un-surprised there are 'quirks'
- Copy Link
- Report Inappropriate Content
I found the same problem, it works now :-) but it should be possible to enable All for easy managed switch
- Copy Link
- Report Inappropriate Content
@ all
The problem is the missing "all" Profiles for Easy-Managed Switches.
We need to manually create port profles and apply them (to the uplink ports too).
- Copy Link
- Report Inappropriate Content
yes I figured it out, I didn't think clear here for a while. but it should have been possible to enable the All profile on easy managed switch, but ok, now I know.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 145
Replies: 6
Voters 0
No one has voted for it yet.