VlanID for oc200 and eap610
Hi,
I bought oc200 and two eap610 to handle fast roaming.
Switch and router are not omada compatible.
I will create 3 sssid for each eap for 3 vlans.
What i woud know is how to configure vlanID of switch for ports connected to oc200 and both eaps.
Will eaps sent traffic tagged for the 3 vlans? I need to sent traffic tagged to eap?
Traffic incoming and outgoing to/from controller on which VLAN has to be?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Antony23, all untagged members on the same vlan. The eap does have an option to set the Management VLAN. If you do that then the management VLAN id would be tagged on the eap's ports.
- Copy Link
- Report Inappropriate Content
Hi @Antony23
The simplest setup is to make the controller and eap ports untagged members of the same vlan with the PVID set as well. The vlans mapped to the SSID need to be tagged on the eap's ports and I assume the router's port too.
- Copy Link
- Report Inappropriate Content
Thanks for the answer.
From your answer i suppose so that management traffic of oc200 and eap610s is untagged, right? My doubt was it was tagged on vlan 1.
- Copy Link
- Report Inappropriate Content
@Antony23, all untagged members on the same vlan. The eap does have an option to set the Management VLAN. If you do that then the management VLAN id would be tagged on the eap's ports.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 98
Replies: 3
Voters 1