Business Community > Switches > sg2005p-pd - checking the temperature via CLI
< Switches

sg2005p-pd - checking the temperature via CLI

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

sg2005p-pd - checking the temperature via CLI

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
sg2005p-pd - checking the temperature via CLI
sg2005p-pd - checking the temperature via CLI
2025-01-10 04:59:08 - last edited 2025-02-24 07:47:11
Tags: #CLI
Model: SG2005P-PD  
Hardware Version: V1
Firmware Version: 1.0.6

Hi all

 

I am trying to get the current temperature of my sg2005p-pd switches. I am using the CLI interface via the software controller and using the enable command i then run the show temperature command only to get Error: Invalid Parameter

 

Does this switch not support this command or do i need to try using another approach?

 

Thanks

 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:sg2005p-pd - checking the temperature via CLI-Solution
2025-01-15 05:42:26 - last edited 2025-02-24 07:47:11

Hi @Kyesys 

Thanks for posting in our business forum.

Kyesys wrote

  @Clive_A Sorry for the delay. I just dropped this switch from the software controller to test the command, it appears to not work when its setup as standalone either.

Do I need to use the feature request section to request this command be added to the switch?

 

Thanks

 

Then it should be this model does not support it.

As stated in the User Guide, the feature is only available to models.

 

Recommended Solution
  1  
  1  
#5
Options
3 Reply
Re:sg2005p-pd - checking the temperature via CLI
2025-01-13 02:02:50

Hi @Kyesys 

Thanks for posting in our business forum.

Some commands are disabled or not available in the Controller mode.

  1  
  1  
#3
Options
Re:sg2005p-pd - checking the temperature via CLI
2025-01-15 05:05:34

  @Clive_A Sorry for the delay. I just dropped this switch from the software controller to test the command, it appears to not work when its setup as standalone either.

Do I need to use the feature request section to request this command be added to the switch?

 

Thanks

 

  0  
  0  
#4
Options
Re:sg2005p-pd - checking the temperature via CLI-Solution
2025-01-15 05:42:26 - last edited 2025-02-24 07:47:11

Hi @Kyesys 

Thanks for posting in our business forum.

Kyesys wrote

  @Clive_A Sorry for the delay. I just dropped this switch from the software controller to test the command, it appears to not work when its setup as standalone either.

Do I need to use the feature request section to request this command be added to the switch?

 

Thanks

 

Then it should be this model does not support it.

As stated in the User Guide, the feature is only available to models.

 

Recommended Solution
  1  
  1  
#5
Options

Information

Helpful: 0

Views: 529

Replies: 3

Tags

CLI
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.