Community Home Page
Home Network Community
Smart Home Community

Search in
- Business Community

- Forums

- Stories

- Knowledge Base

Home

Forums

Omada

Wireless Switches Gateways Controllers Accessories Requests & Suggestions Official Announcements General Discussion

VIGI

Cameras Video Recorders Solar Power System Software Service Accessories Requests & Suggestions General Discussion

More Products

SOHO Switches Load Balance Gateways Pharos Wireless Bridges Festa Requests & Suggestions General Discussion

Omada
- Wireless
- Switches
- Gateways
- Controllers
- Accessories
- Requests & Suggestions
- Official Announcements
- General Discussion
VIGI
- Cameras
- Video Recorders
- Solar Power System
- Software Service
- Accessories
- Requests & Suggestions
- General Discussion
More Products
- SOHO Switches
- Load Balance Gateways
- Pharos Wireless Bridges
- Festa
- Requests & Suggestions
- General Discussion

Stories

Knowledge Base

Business Community > Requests & Suggestions > Feature Request: AFC (Automated Frequency Coordination) Support for Indoor Wifi 7 AP's (EAP 783/773)

< Requests & Suggestions

Votes

Feature Request: AFC (Automated Frequency Coordination) Support for Indoor Wifi 7 AP's (EAP 783/773)

Votes

Feature Request: AFC (Automated Frequency Coordination) Support for Indoor Wifi 7 AP's (EAP 783/773)

Registered: 2024-03-27

MrAdministrator

2025-01-22 17:14:34 - last edited 2025-04-09 16:02:31

Posts: 41

Helpful: 25

Solutions: 1

Stories: 0

Registered: 2024-03-27

Feature Request: AFC (Automated Frequency Coordination) Support for Indoor Wifi 7 AP's (EAP 783/773)

2025-01-22 17:14:34 - last edited 2025-04-09 16:02:31

Tags:

Model: EAP783

Hardware Version: V1

Firmware Version: 1.1.90

Add support for AFC for the Wifi 7 AP's with 6GHz radios. This feature was confirmed to reviewers as coming in a firmware update, however now I've been told it's not planned at this time.

The current implementation of broadcasting a 22dBm beacon with only one antenna and ramping up the power and antennas under load is a poor solution. The low broadcast power causes issues with band selection and device roaming. It also means burst data requests are fulfilled with low broadcast power and therefore low bandwidth. It takes several seconds before the radio ramps power up.