Hi,

Recently, I keep getting random disconnects on EAPs controlled by an AC200. (They were fine before.) I have 5 outdoor EAP225s, 3 of them have HW v1.0 running 5.1.6, and 2 are HW v3.0 running 5.1.10, which I believe are the latest FWs.

The EAPs are being used normally until the clients just lose connection. I would check the OC200 GUI and always I could see the device EAP status as DISCONNECTED. It would stay this way indefinitely. They is no way from the GUI to restore, I need to manually power cycle the actual EAPs in order to get them back, at which point the GUI shows the normal sequence of adoption/provisionning, which is always successful anyways. This has been happening at a frequency of about once or twice weekly, and it's been several weeks. On the logs there is not much to see, only the event when the device was disconnected and reconnected.

As you may imagine, this is so much hassle as some physical locations of the EAPS are a bit difficult to access.

I have searched the posts here and could not find a similar scenario. Please kindly help. Thank you.