Director, IS&T

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Director, IS&T

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Director, IS&T

Dva

2014-02-11 12:18:19 - last edited 2021-08-21 03:49:24

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2014-02-11

Director, IS&T

2014-02-11 12:18:19 - last edited 2021-08-21 03:49:24

Region : Canada

Model : TL-ER6120

Hardware Version : V1

Firmware Version : 1.0.6 Build 20131129 Rel.49461

ISP :

Hello, I am connected via a PPPoE connection with an assigned, static IP. I have a secondary connection via that PPPoE connection with a /29 network. I am trying to configure the DMZ in public mode, awarding the DMZ interface the first usable IP within the /29 but when I try to save the config it fails.
Can any one shed some light on this?

Cheers,

Dva

2 Reply

golf

LV2

2014-02-11 15:10:04 - last edited 2021-08-21 03:49:24

Posts: 34

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2013-11-12

Re:Director, IS&T

2014-02-11 15:10:04 - last edited 2021-08-21 03:49:24

to use the public mode of DMZ, you need at least 3 public ip address; one for WAN one for DMZ and one for your server. Also, DMZ and server should be in the same sub-network

Dva

LV1

2014-02-11 21:35:21 - last edited 2021-08-21 03:49:24

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2014-02-11

Re:Director, IS&T

2014-02-11 21:35:21 - last edited 2021-08-21 03:49:24

Thanks Golf...the /29 provides me with 5 usable addresses. In addition to that I have the single static which provides me with a total of 6 public ips. I tried awarding the network address to the DMZ but it won't accept a network address, it must be a host address.

Director, IS&T

Director, IS&T

Information

Voters 0

Tags