Tl-ER604W V1 - How to Route additional subnets through a VPN client connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tl-ER604W V1 - How to Route additional subnets through a VPN client connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tl-ER604W V1 - How to Route additional subnets through a VPN client connection
Tl-ER604W V1 - How to Route additional subnets through a VPN client connection
2014-06-02 18:08:40 - last edited 2021-08-21 03:58:35
Region : France

Model : TL-ER604W

Hardware Version : V1

Firmware Version :

ISP : monaco telecom


I have successfully setup a VPN Client connection from home router into our office (Windows based PPTP server)

my home has subnet 192.168.50.x and the office has 192.168.0.x

any traffic i route to 192.168.0.x correctly routes. However the office then has other subnets 192.168.10.x 192.168.20.x and so forth.

How can i set up a static route to route these subnets onto the pptp interface ?
in the static route setup page it gives me interface WAN1 WAN2 LAN - whichever interface i use does not work

On the "next hop" i have tried putting both the the gateway on the remote office network that routes to the other subnets (192.168.0.254) and the local IP that connects to my home network.

In the routing table it shows me "pptp-vpn-0" for the connected VPN - but how can i direct traffic into that logical interface ?
  0      
  0      
#1
Options

Information

Helpful: 0

Views: 683

Replies: 0