How to create a L2TP connection TL-R600VPN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to create a L2TP connection TL-R600VPN
Region : Argentina
Model : TL-R600VPN
Hardware Version : V2
Firmware Version :
ISP :
Good day, I am having trouble connecting with L2TP.
My setup is as follows: I want to let employees connect to a windows remote desktop server:
So I have 1 Dlink ADSL router. (connected to internet PPPoe) but also bridged to allow other PPPoe dialups.
I have 1 static IP address that I must configure for L2TP connection (IPSec not supported).
I have 1 24port Hub.
the setup guides can be found at https://www.axxess.co.za/staticip.php#setup
The problem also is I am unable to access the R600VPN's settings when I plug in the network cables.
Where does the WAN cable go? (I think to the 24port hub)
Where does the LAN cable go? (I think to the ADSL router)
I'm completely lost. Any help appreciated.
Kind Regards
Peter:cool:
Model : TL-R600VPN
Hardware Version : V2
Firmware Version :
ISP :
Good day, I am having trouble connecting with L2TP.
My setup is as follows: I want to let employees connect to a windows remote desktop server:
So I have 1 Dlink ADSL router. (connected to internet PPPoe) but also bridged to allow other PPPoe dialups.
I have 1 static IP address that I must configure for L2TP connection (IPSec not supported).
I have 1 24port Hub.
the setup guides can be found at https://www.axxess.co.za/staticip.php#setup
The problem also is I am unable to access the R600VPN's settings when I plug in the network cables.
Where does the WAN cable go? (I think to the 24port hub)
Where does the LAN cable go? (I think to the ADSL router)
I'm completely lost. Any help appreciated.
Kind Regards
Peter:cool: