WAN1+WAN2 use FailOver why WAN2 cannot "PING"?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WAN1+WAN2 use FailOver why WAN2 cannot "PING"?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WAN1+WAN2 use FailOver why WAN2 cannot "PING"?
WAN1+WAN2 use FailOver why WAN2 cannot "PING"?
2015-02-02 00:24:18 - last edited 2021-08-21 04:40:53
Region : UnitedStates

Model : TL-R480T

Hardware Version : Not Clear

Firmware Version :

ISP :


Dear All

I wonder why I setting up a Fail Over Service on TL-480T with two WAN (WAN1 & WAN2) but I cannot ping to WAN2 when WAN1 is Active, after I disable WAN1 I can ping normally.
So is there any setting to allow both WAN ping at the same time.


Please help me.
Regards
  0      
  0      
#1
Options
2 Reply
Re:WAN1+WAN2 use FailOver why WAN2 cannot "PING"?
2015-02-03 10:06:12 - last edited 2021-08-21 04:40:53
WAN2 is the backup, isn't it?
If so, when WAn1 is activated, WAN2 is deactivated. It is quite normal that you cannot ping it.
If you want to ping both, you should not enable link backup.
  0  
  0  
#2
Options
Would that make the Wan 2 go down after a 10 minute period
2015-02-12 15:10:24 - last edited 2021-08-21 04:40:53
Hey to all

I have a TL-R480T+ Ver 5 and I conf that option too, with the failover and I think because of that my Wan2 goes down after a period of 10 minutes of activity. If that is so, Pls confirm that
so I can correct it so I will have a better INTERNET for my company.


Thank you.

Best reagards,

Franklin.
  0  
  0  
#3
Options