TL-ER604W ipsec remote subnet conflicts
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-ER604W ipsec remote subnet conflicts
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Setting up multiple ipsec VPN policies for my clients so I can connect on demand when required for support.
The current firmware on this router (1.1.0 Build 20141031 Rel.32628s) will not allow configuring more than one policy with the same remote subnet even if they are not active. It seems that the subnet check is done at policy creation not at policy activation where it should be to avoid conflicts.
You need to need to change this ASAP and issue a new firmware update as the current available firmware is 10 months old. This is fundamental to allowing 30 ipsec VPNs on this device that you will have more than 1 remote subnet the same. The subnet check should be done on policy activation not on policy creation.
Any help would be appreciated.
Hardware Version : Not Clear
Firmware Version :
ISP :
Setting up multiple ipsec VPN policies for my clients so I can connect on demand when required for support.
The current firmware on this router (1.1.0 Build 20141031 Rel.32628s) will not allow configuring more than one policy with the same remote subnet even if they are not active. It seems that the subnet check is done at policy creation not at policy activation where it should be to avoid conflicts.
You need to need to change this ASAP and issue a new firmware update as the current available firmware is 10 months old. This is fundamental to allowing 30 ipsec VPNs on this device that you will have more than 1 remote subnet the same. The subnet check should be done on policy activation not on policy creation.
Any help would be appreciated.