How to urtilize more than one static IP on TL-R470T+

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to urtilize more than one static IP on TL-R470T+

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

blamar@teamlog

2015-10-20 08:25:38 - last edited 2021-08-21 05:25:05

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2015-10-20

How to urtilize more than one static IP on TL-R470T+

2015-10-20 08:25:38 - last edited 2021-08-21 05:25:05

Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hello:
I have a TL-R470T+ wan balancing router configured with a static IP for WAN1 and not using the WAN2 port.
I have 6 static IP's based on my 255.255.255.248 mask (/29)
I cannot bean into my router on any of the other IP addresses (.10-.14)

Can you please tell me what I cam doing incorrectly?

I'm wondering if I need to put a switch before my router and set the WAN2 port up with a different static IP....but that way, the most I could use would be 4?? Seems strange. (I would be OK with only using 4 if that is the correct approach)

Thank you for any assistance.

Ben

2 Reply

Tony Seaford

LV5

2015-10-20 09:12:40 - last edited 2021-08-21 05:25:05

Posts: 591

Helpful: 14

Solutions: 1

Stories: 0

Registered: 2015-02-27

Re:How to urtilize more than one static IP on TL-R470T+

2015-10-20 09:12:40 - last edited 2021-08-21 05:25:05

Is it what you need?
http://www.tp-link.com/en/faq-887.html

blamar@teamlog

LV1

2015-10-21 02:11:26 - last edited 2021-08-21 05:25:05

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2015-10-20

Re:How to urtilize more than one static IP on TL-R470T+

2015-10-21 02:11:26 - last edited 2021-08-21 05:25:05

Thank you for thew reply.

This is not what I'/m trying to do; while reading over the posts yesterday there was someone who was looking for this exactl information though.

My situation should be much simpler. I have subscribed to 6 static IP addresses from my ISP, .9 through .14. (A 255.255.255.248 or /29 subnet mask)

I have entered .9 into my WAN config and everything works perfectly. The problem is that I now need to use another one of my static IP's for a different service. .10. let's say. I cannot reach my router from any of the static IP's except .9 I am looking for a way to be able to use a second private ip along with .9.

In other firewalls I have used, simply setting up the wan configuration with the /29 subnet is enough...but the TP=LINK R470 T+ doesn't seem to support this convention.

I hope this clarifies my issue more.

Ben

How to urtilize more than one static IP on TL-R470T+

How to urtilize more than one static IP on TL-R470T+

Information

Voters 0

Tags