TP-Link Omada SG3428XMPP V.1 user CCTV camera Bandwidth full 100%
TL-SG3428XMPP 1.0 connect CCTV camera at Bandwidth Utilization will show TX Bandwidth Utilization 100% all the time
Computer and Access point can use normally. have a problem only cctv camera
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If you do not experience an issue in the real environment, it could be a visual error.
Try to upgrade your firmware and check this again.
https://support.omadanetworks.com/en/product/tl-sg3428xmp/v1/?resourceType=download
- Copy Link
- Report Inappropriate Content
I have discovered the issue, it is caused by the VLAN settings of another connected device (SX3008F > SG3428XMPP), the Uplink port does not have the VLAN set to Tagged.
- Copy Link
- Report Inappropriate Content
If you do not experience an issue in the real environment, it could be a visual error.
Try to upgrade your firmware and check this again.
https://support.omadanetworks.com/en/product/tl-sg3428xmp/v1/?resourceType=download
- Copy Link
- Report Inappropriate Content
I have discovered the issue, it is caused by the VLAN settings of another connected device (SX3008F > SG3428XMPP), the Uplink port does not have the VLAN set to Tagged.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 190
Replies: 2
Voters 0
No one has voted for it yet.