Route all traffic through ipsec VPN with TL-R600VPN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Route all traffic through ipsec VPN with TL-R600VPN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Route all traffic through ipsec VPN with TL-R600VPN
Route all traffic through ipsec VPN with TL-R600VPN
2015-11-18 14:08:36 - last edited 2021-08-21 05:00:26
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

I am using a TL-R600VPN as an endpoint for a small office. I have the site-to-site setup and working properly for the specified networks, but I want to route all traffic from the remote site (using theTL-R600VPN) though the VPN connection to the main site. I tried to add a route for 0.0.0.0 but receive an error "Error code: 4001. Bad destination IP address, please input another one." How do I direct all outbound traffic to the remote vpn site (and the remote site will route traffic to the internet as needed)?

Remote Site ->> TL-R600VPN --> Site-To-Site VPN --> Main Site VPN --> Internet
  1      
  1      
#1
Options
1 Reply
Re:Route all traffic through ipsec VPN with TL-R600VPN
2015-11-24 09:18:59 - last edited 2021-08-21 05:00:26
I remember there is a VPN configuration manual in TP-link's official website, you can refer to it for help.
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 1282

Replies: 1