HelloI have a problem with the OC300 controller.After connecting it to the router with the address 192.168.1.1, it changes the address to 192.168.0.1.I have to reset the router to factory settings.And the entire building security system operates on 192.168.0.1.The controller is supposed to be used to check the functionality of this system.I would like assistance in resolving this issue.I am attaching a reference drawing.Best regards
Hi @kokerd
Thanks for posting here. This is because the LAN IP for the controller is 192.168.0.1 by default. Once the router is adopted by the router, it will apply the controller settings.
To avoid this situation, you need to change the LAN IP of the default LAN on the controller first.
Below is a guide:
How to add an Omada Gateway to the network? (Controller 4.4.3 or above)
The screenshots were from an older interface, but the steps are basically the same.
Hi @kokerd
Thanks for posting here. This is because the LAN IP for the controller is 192.168.0.1 by default. Once the router is adopted by the router, it will apply the controller settings.
To avoid this situation, you need to change the LAN IP of the default LAN on the controller first.
Below is a guide:
How to add an Omada Gateway to the network? (Controller 4.4.3 or above)
The screenshots were from an older interface, but the steps are basically the same.
Helpful: 0
Views: 280
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
