Hi everyone,

I am trying to set up a "Teleportation VLAN" where a specific VLAN routes out to a commercial WireGuard VPN (KeepSolid), but the rest of my network stays on the main WAN.

I have the ER8411 Gateway managed by the Omada Controller OC 300. I have successfully established the WireGuard tunnel (Handshake is good, data flows).

The Problem:

I cannot find a way to apply a Policy Route to this WireGuard interface.

Transmission > Routing > Policy Routing: The "WAN" dropdown only lists physical ports (WAN/LAN1, SFP+, etc.), not the VPN interface.

VPN > VPN Policy: The "VPN Type" dropdown lists OpenVPN, IPsec, L2TP, and PPTP, but WireGuard is missing.

What I have tried:

If I set AllowedIPs = 0.0.0.0/0 in the Peer settings, the router installs a global default route and forces ALL my traffic (Main LAN included) through the VPN.

If I change 0.0.0.0/0 to my VLAN subnet, the VPN connects but no traffic flows through it because there is no policy directing VLAN 60 to use it and it seems backwards. The only solution I see is to use OpenVPN or other VPN type.

Question:

Is there any way on the current ER8411 firmware to use WireGuard as an interface in Policy Routing? Or is WireGuard on Omada currently strictly "All-or-Nothing" via the AllowedIPs field?

Thanks!