SG3218XP-M2 v1.0 after FW update to 1.019 no 2,5Gbps connection to EAP 673 v1.0
Hello everyone.
After updating the firmware of my SG3218XP-M2 v1.0 from version 1.0.16 to 1.0.19, the 2.5 Gbps connection to my EAP673 v1.0 (firmware v1.1.1) no longer works.
It repeatedly attempts to adopt the device but usually fails.
Even when it does adopt, it's listed as connected to the wrong device in the connection overview, and after a while, the connection drops again.
This happens regardless of the cable I use; even with a direct connection using a 5m Cat. 7 cable, a stable 2.5 Gbps connection isn't possible.
It worked flawlessly with the previous firmware, version 1.0.16.
The only workaround at the moment is to reduce the connection speed to 1 Gbps.
The Omada Controler is V6.1.0.19
Has anyone else experienced this problem, and is there a solution?
Best regards, Thorsten
Hi @Hank21
Thanks for your answer.
May I ask what is your network topology?
I share the topology screenshot.
If the port speed set to 1G, the EAP673 V1 can be adopted without problem?
Yes I have set the port speed to 1G and then it works fine.
What "wrong" device the EAP673 connects to when it is adopted?
If the EAP 673 connect with 2.5G he shows connect to the Gateway ER7412-M2
If it failed to be adopted ,what was the error message?
With 2,5G port speed ist shows follow messages:
adopt / adopt failed / adopt / connected / provisioning / connected / heartbeat missed / disconnect
| Feb 10, 2026 16:28:15 | TXXXXX | Devices | Fehlgeschlagen |
XX-20-51-14-XX-XX failed to adopt. |
Greetings Thorsten