ER707-M2 v1.20 running 1.4.1 Build 20260325 Rel.78146
Local management. No Controller.
Load Balance - On.
tried Lower weight on Wan1 and Higher on WAN/LAN2 (reversed, same result)
tried Enable Application Optimized Routing
It DOES FO and Failback. but then settles on WAN2 always. (Wan2 is my slower backup connection,. I need to "Use First Primary WAN1" unless its down.
@Tarkin In standalone mode, Always Failover mode is the default, and you cannot change the setting. This may be an issue with Online Detection for WAN1; can you make sure the uplinks are working fine? Also, check if there are any logs showing the WAN came back up.
Hi @Tarkin
Thanks for posting here.
Does the issue persist?
When link backup is enabled, the following config will not take effect. You may disable them
Load Balance - On.
tried Lower weight on Wan1 and Higher on WAN/LAN2 (reversed, same result)
tried Enable Application Optimized Routing
Helpful: 0
Views: 82
Replies: 3
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
