ER707-M2 always uses backup link evem when primary is available
ER707-M2 v1.20 running 1.4.1 Build 20260325 Rel.78146
Local management. No Controller.
Load Balance - On.
tried Lower weight on Wan1 and Higher on WAN/LAN2 (reversed, same result)
tried Enable Application Optimized Routing
It DOES FO and Failback. but then settles on WAN2 always. (Wan2 is my slower backup connection,. I need to "Use First Primary WAN1" unless its down.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Tarkin In standalone mode, Always Failover mode is the default, and you cannot change the setting. This may be an issue with Online Detection for WAN1; can you make sure the uplinks are working fine? Also, check if there are any logs showing the WAN came back up.
- Copy Link
- Report Inappropriate Content
Hi @Tarkin
Thanks for posting here.
Does the issue persist?
When link backup is enabled, the following config will not take effect. You may disable them
Load Balance - On.
tried Lower weight on Wan1 and Higher on WAN/LAN2 (reversed, same result)
tried Enable Application Optimized Routing
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 99
Replies: 4
Voters 0
No one has voted for it yet.