tunnel eogre controlador oc200
Good afternoon everyone!
I’m trying to connect two sites (ER706W and ER605 with an EAP615 Wall) using an EoGRE tunnel. I can’t seem to get it configured—has anyone managed to do this?
I’m using an Omada OC200 controller v6.2.0.17.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@prisko There is an FAQ for the set up here: How to set up an SSID with EoGRE Tunnel using Omada EAP | Omada Network Support
However, as mentioned in my previous reply, the ER706W only supports hosting the EoGRE tunnel in standalone mode. If you would like to connect them, the ER706W must be in standalone mode.
- Copy Link
- Report Inappropriate Content
@prisko To confirm, you are trying to connect the EAP615-Wall, which is behind the ER605, to the ER706W via an EoGRE tunnel? If so, is the ER706W adopted in the controller, or in standalone? I'm seeing that the ER706W only supports GRE in standalone mode, so just double checking.
- Copy Link
- Report Inappropriate Content
@NeilR_M Yes, I am trying to connect with a tunnel EoGRE a wlan of an EAP615 wall with gateway ER605. The server is ER705w and all the devices are adopted by a controller OC200. For that the two sites have a VPN IPSECIKEV2 between each LAN of the devices.
As each site has its different public IP with the tunnel EoGRE i would like the public IP of site 1 with multicast traffic on layer 2 a wlan in site 2. Do you think this could be possible? Could you help me?
- Copy Link
- Report Inappropriate Content
@prisko There is an FAQ for the set up here: How to set up an SSID with EoGRE Tunnel using Omada EAP | Omada Network Support
However, as mentioned in my previous reply, the ER706W only supports hosting the EoGRE tunnel in standalone mode. If you would like to connect them, the ER706W must be in standalone mode.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 79
Replies: 3
Voters 0
No one has voted for it yet.