EAP245(EU) v3.0 is no longer supported by Omada?
Hello! EAP245(EU) v3.0 is no longer supported by Omada?
Omada_SDN_Controller_v6.2.10.17 cannot adapt the access point.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thanks for reaching out to TP-Link Business Forums.
What's the error message when you failed to adopt this EAP? Could you please provide a screenshot of that?
The latest firmware for this EAP245 V3.0 is V5.3.3. You can upgrade it to the latest firmware and then try again. EAP245 | AC1750 Wireless MU-MIMO Gigabit Ceiling Mount Access Point | Omada Network Support
- Copy Link
- Report Inappropriate Content
I was able to determine that the problem is most likely related to 100% CPU utilization on the eap245.
I installed the latest firmware, 5.3.3.
I have four of these access points, and all have 100% CPU utilization at the same time. The load on the access points is minimal.
The load is 100% even on access points that don't have clients connected.
Memory utilization is 60-70%.
How can I tell what's consuming the processor at 100%?
After rebooting by powering off the access point itself, the CPU utilization drops.
The other two access points, the EAP115-Wall(EU) v1.0 and EAP235-Wall(EU) v1.0, don't have this kind of CPU utilization.
My controller is software-based.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 94
Replies: 2
Voters 0
No one has voted for it yet.