TL-ER5120 policy routing not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-ER5120 policy routing not working
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi, maybe I'm doing something wrong (or missing something)
Model: TL-ER5120
Firmware Version: 1.0.8 Build 20140212 Rel:36037
Hardware Version: TL-ER5120 v2.0
I have two ISP: ISP1 on WAN1 and ISP2 on WAN2
Port 5 is connected to the LAN switch.
All PC have static IP.
I want to allow 1 particular IP (192.168.0.53) to navigate over WAN2 and the rest of network through WAN1
I followed instructions from FAQ but I couldn't get this working
I've set
Network -> System Mode: NAT
Advanced -> Load Balance: Enable Application Optimized Routing: checked
Advanced -> Load Balance: Enable Bandwidth Based Balance Routing: checked
both WAN ports checked
Also, in Advanced -> Load Balance -> Policy Routing I made two rules:
Rule1
Source IP 192.168.0.53 - 192.168.0.53
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN2
Rule2
Source IP 192.168.0.1 - 192.168.0.254
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN1
to ensure rest of network will use WAN1
So (if my logic works) if IP 192.168.0.53 wants to navigate, would do using WAN2, and the rest would do on WAN1.
But this is not working. IP 53 still navigating on WAN1
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi, maybe I'm doing something wrong (or missing something)
Model: TL-ER5120
Firmware Version: 1.0.8 Build 20140212 Rel:36037
Hardware Version: TL-ER5120 v2.0
I have two ISP: ISP1 on WAN1 and ISP2 on WAN2
Port 5 is connected to the LAN switch.
All PC have static IP.
I want to allow 1 particular IP (192.168.0.53) to navigate over WAN2 and the rest of network through WAN1
I followed instructions from FAQ but I couldn't get this working
I've set
Network -> System Mode: NAT
Advanced -> Load Balance: Enable Application Optimized Routing: checked
Advanced -> Load Balance: Enable Bandwidth Based Balance Routing: checked
both WAN ports checked
Also, in Advanced -> Load Balance -> Policy Routing I made two rules:
Rule1
Source IP 192.168.0.53 - 192.168.0.53
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN2
Rule2
Source IP 192.168.0.1 - 192.168.0.254
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN1
to ensure rest of network will use WAN1
So (if my logic works) if IP 192.168.0.53 wants to navigate, would do using WAN2, and the rest would do on WAN1.
But this is not working. IP 53 still navigating on WAN1