Business Community > Routers > Remote management on TL-ER5120 - access from external IP
< Routers

Remote management on TL-ER5120 - access from external IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Remote management on TL-ER5120 - access from external IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Remote management on TL-ER5120 - access from external IP
Remote management on TL-ER5120 - access from external IP
2016-09-07 12:56:42 - last edited 2021-04-19 11:47:19
Model : ES5120

Hardware Version : v2

Firmware Version : 1.0.8

ISP : Zen, Plusnet

No problem accessing my router, a TL-ER5120 from my LAN. Before I left home on business I enabled remote access.but I didn't sped much time on the IP ranges hoping that if I leave the range at the default 0.0.0.0. then it would default to open access from all IP's - this appears to have been WRONG, hehe

Whats the best / most secure way to allow access from any IP address whilst I travel around?

Here is the relevant page in the manual, can't really get to grips with this :





Any advice appreciated

Chunks
  0      
 
  0      
 
#1
Options
3 Reply
Re:Remote management on TL-ER5120 - access from external IP
2016-09-09 23:33:48 - last edited 2021-04-19 11:47:19
OK, so its not in the manual, that I can find and I have been googling and on some other TP-Link routers you can use the following subnet masks :

EDIT : I found the solution :

You need to enter 0.0.0.0 /32 subnet into the GUI, this opens access to all internet IP's (but still requires username and password

Chunks
  0  
  0  
#2
Options
Re:Remote management on TL-ER5120 - access from external IP
2019-10-28 08:01:20 - last edited 2021-04-19 11:47:19

@Chunkers My Ruter ip is 192.168.0.1 how to Manage ???

  0  
  0  
#3
Options
Re:Remote management on TL-ER5120 - access from external IP
2019-10-29 01:23:41 - last edited 2021-04-19 11:47:19
If you need to manage your router from LAN, just access 192.168.0.1. If you need to access from WAN, you need to set up remote management. TP-Link should has the FAQ for this function.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 2288

Replies: 3

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.