Did you configure LAN to LAN IPsec VPN?

Dear Friends,I have one project and need your help for completion this.3 different sites which are directly/indirectly connected to cisco VPN router RV042 and we want to make a vpn between them, how can we make it, please discuss step wise actually i am very new to cisco.Thanku waiting for ur responses.

I do not have a tutorial but many routers has built in VPN support so you do not need any PC to create a VPN tunnel. You can set it up between two routers./micke

lcford1978 wrote

Model :

Hardware Version :

Firmware Version :

ISP :

I have 2 TL-ER6020's and have configured them as per the instructions to setup a VPN between them. It says they are connected and active but I can't see any devices on the other side. Any thoughts?

I am experiencing the exact same problem with 2 of the same router model. Lan to Lan IPSEC VPN is active and connected, but no traffic will pass through the VPN tunnel from either side. Were you or anyone else able to resolve this?

I am experiencing the exact same issue with the same routers (two ER6020s). Lan-to-Lan IPSEC VPN shows the tunnel is active and connected, but no traffic will pass through the tunnel from either side. Were you or anyone able to resolve this problem?

Well that's strange. You can see the list of IPSec SA right? Could you ping each site successfully?