Unable to access network remotely on wan 2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to access network remotely on wan 2
Model : TL-R470T+
Hardware Version : Not Clear
Firmware Version : 1.1.0
ISP :
I have 2 wans. Wan1 on cable modem. Wan 2 on ADSL.
Wan1 is setup as Primary and Wan 2 as backup
I do not have bandwith balance routing setup.
If I disconnect Wan1 it switches in about 10 seconds no problem to Wan2.
Internet is available on all devices on the lan.
The problem is I cannot remotely access anything from outside the network.
Teamviewer says no connection on my pc (always on)
[*]Noip cannot get an ip address
[*]Even if I punch in the wan2 public ip +port I cannot access the network
On the same pc with team viewer blueiris is running and it's webserver syncs and detects wan2 public ip.
However I cannot access blueiris remotely even if I punch in the public ip of wan 2 and the port of the blueiris server.
What am I missing, I figured the router would handle this easy peasy. !
Would appreciate any help,, going bonkers !
Hardware Version : Not Clear
Firmware Version : 1.1.0
ISP :
I have 2 wans. Wan1 on cable modem. Wan 2 on ADSL.
Wan1 is setup as Primary and Wan 2 as backup
I do not have bandwith balance routing setup.
If I disconnect Wan1 it switches in about 10 seconds no problem to Wan2.
Internet is available on all devices on the lan.
The problem is I cannot remotely access anything from outside the network.
Teamviewer says no connection on my pc (always on)
[*]Noip cannot get an ip address
[*]Even if I punch in the wan2 public ip +port I cannot access the network
On the same pc with team viewer blueiris is running and it's webserver syncs and detects wan2 public ip.
However I cannot access blueiris remotely even if I punch in the public ip of wan 2 and the port of the blueiris server.
What am I missing, I figured the router would handle this easy peasy. !
Would appreciate any help,, going bonkers !
