Business Community > Pharos Wireless Bridges > How do I connect 3 buildings using CPE510 hardware
< Pharos Wireless Bridges

How do I connect 3 buildings using CPE510 hardware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
123

How do I connect 3 buildings using CPE510 hardware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
27 Reply
Re:How do I connect 3 buildings using CPE510 hardware
2017-09-29 15:47:21
You're welcome, johntkc.

M@rius, as for fluctuations in signal quality, this is strange. Can't imagine that both CPEs on the same pole are interfering if on different channels that much, but you could find out by exchanging the channel assignment between the two. Does the first CPE behave the same way if channels are exchanged? If not, it could be either a HW problem or power problem as RTouris presumes. Also check wether it changes if you use MAXtream and consider PtMP mode for testing. Does anything change if you use fixed 802.11n mode?
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#22
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-01 00:42:34
RTouris my setup is quite direct with cable just 3 m long, let me explain, from my house I have a CPE in AP mode, 1,6 km away on a pole I have a CPE in client mode and from it with PoE passthrougt with 3 m cable i go to the third CPE again in AP mode and finaly 800 m away I have the last CPE in Client mode.
R1D2 changing to 802.11n or a had a dramatic efect in a bad way the quality drooped to 38%, what I noticed is that my AP with no client connected is at 100% but as soon as the client connects quality is drooping to 60%
  0  
  0  
#23
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-01 00:51:44
hmmm .... something changed for the better in802.11a, AP is at 100% and the client at 80 - 93 %, some times drops to 68
  0  
  0  
#24
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-01 01:00:03
also ping time to the second CPE is excellent 2-3 ms . I'm quite happy with this
  0  
  0  
#25
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-02 05:05:47
off the top of my head..Isn't 802.11a **only** up to 54mbps? (could be mistaken)...
Now serving finite customer via f(x)=AirTime/∞ on the 5Ghz band :-/
  0  
  0  
#26
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-02 08:53:16
Yes, 802.11a is 54 Mbps and 20 MHz channel width only.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#27
Options
Re:How do I connect 3 buildings using CPE510 hardware
2017-10-08 19:31:36
Likely
  0  
  0  
#28
Options
123
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.