Can't login to Web Management on CPE210
Can't login to Web Management on CPE210
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a new CPE210 which took me forever to login to despite following all instructions and setting up a static address on my computer. Somehow, I finally managed to get into the web management. I then updated the CPE210 to the newest firmware without problems. I then set up the CPE210 for AP mode with two SSID's. I also changed the IP of the CPE210 192.168.0.254 to 192.168.1.5. The CPE210 required me to log back in after changing the IP. After that, I had everything set up so I logged out and plugged the CPE210 into a switch. The two SSID's showed up on my computer's wireless, but I could no longer login to the CPE210.
I took the CPE210 off of the switch and reattached it to the computer and now the CPE210 will not allow me to log into it as I did the first time around. I tried a factory reset, used the old IP address 192.168.1.254 and am still not able to access web management. I have been through this whole procedure again after bringing the CPE210 home (I tried to install it at my vacation home where I currently have a CPE510 installed, which is working). Somehow, after a number of factory resets and plugging in and unplugging the CPE210 I was able to finally get back into web management and set everything up. After that, I again could not get back into the CPE210 after connecting it to my switch.
I am beginning to think that the CPE210 I have is faulty. As I mentioned, I have a CPE510 that works fine.
I hope someone can help. Thanks in advance.
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a new CPE210 which took me forever to login to despite following all instructions and setting up a static address on my computer. Somehow, I finally managed to get into the web management. I then updated the CPE210 to the newest firmware without problems. I then set up the CPE210 for AP mode with two SSID's. I also changed the IP of the CPE210 192.168.0.254 to 192.168.1.5. The CPE210 required me to log back in after changing the IP. After that, I had everything set up so I logged out and plugged the CPE210 into a switch. The two SSID's showed up on my computer's wireless, but I could no longer login to the CPE210.
I took the CPE210 off of the switch and reattached it to the computer and now the CPE210 will not allow me to log into it as I did the first time around. I tried a factory reset, used the old IP address 192.168.1.254 and am still not able to access web management. I have been through this whole procedure again after bringing the CPE210 home (I tried to install it at my vacation home where I currently have a CPE510 installed, which is working). Somehow, after a number of factory resets and plugging in and unplugging the CPE210 I was able to finally get back into web management and set everything up. After that, I again could not get back into the CPE210 after connecting it to my switch.
I am beginning to think that the CPE210 I have is faulty. As I mentioned, I have a CPE510 that works fine.
I hope someone can help. Thanks in advance.