EAP Controller in AWS Wont pick up APs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP Controller in AWS Wont pick up APs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP Controller in AWS Wont pick up APs
EAP Controller in AWS Wont pick up APs
2017-02-07 16:49:44
Model : EAP110

Hardware Version :

Firmware Version :

ISP :

Hi all, some advise, please. I have read and re-red the FAQ http://www.tp-link.com/en/faq-913.html and watched the youtube video https://www.youtube.com/watch?v=eTLqcPt19Sc several times and all goes well after the APs (3x EAP 110) are discovered, then I use Batch Settings to assign the elastic IP and the Discover Utility indicates that Setting Succeed on all three, however they don't appear as Pending in the EAP Controller software running on AWS. I have had them setup previously in EAP Controller software running on a lappie but I reset them to shift to the EAP controller in the cloud. I have done and re done several times but no go???? Any ideas .... Please :-) Regards, Mick
  0      
  0      
#1
Options
4 Reply
Re:EAP Controller in AWS Wont pick up APs
2017-02-07 20:44:56
Did you allow access to ports 8088, 8043, 29811, 29812, 29813 and UDP port 29810 in the AWS instance? See the FAQ http://www.tp-link.com/en/faq-1248.html. Works for me.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:EAP Controller in AWS Wont pick up APs
2017-02-09 08:51:08
Hi R1D2, thanks for the reply. All the aforementioned ports are open and I have checked and rechecked. I followed the instructions to the letter. It is very frustrating. The APs won't show up in the EAP Controller. Any thoughts??
Regards, Mick
  0  
  0  
#3
Options
Re:EAP Controller in AWS Wont pick up APs
2017-02-09 11:20:47
No idea. I just connected two more EAP110s to the EAP controller running in AWS and it worked like a charm, although with the second device it took long time (~ 20 minutes) until it changed from " configuring" state to " connected", so sometimes there seem to be sort of hickups. Did you check latest firmware and controller software versions? Any IP address filtering active in AWS?
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:EAP Controller in AWS Wont pick up APs
2017-02-09 22:32:43
Hi R1D2, thanks again for the reply. I decided to terminate the Instance and start from scratch. Eureka!! all good this time around so must have buggered something up the first time.
  0  
  0  
#5
Options