DHCP clients don't show if IP is set manually
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
DHCP clients don't show if IP is set manually
Model : TL-ER6120
Hardware Version : TL-ER6120 v1.0
Firmware Version : 1.0.7 Build 20140113 Rel.63736
ISP : TWC
So I am having an issue were client computers with manually set IP addresses don't show in the DHCP client tab of the router. So it seems that the router can only see .. or show me devices that actually get IP addresses from the router. This pretty bad for security because one way hackers can sit and lurk on your network is by using a manual IP address or even better spoofing one that is. I need to see every device transmitting traffic through the router regardless if they get an IP address from the router or not. Please fix this ASAP
Hardware Version : TL-ER6120 v1.0
Firmware Version : 1.0.7 Build 20140113 Rel.63736
ISP : TWC
So I am having an issue were client computers with manually set IP addresses don't show in the DHCP client tab of the router. So it seems that the router can only see .. or show me devices that actually get IP addresses from the router. This pretty bad for security because one way hackers can sit and lurk on your network is by using a manual IP address or even better spoofing one that is. I need to see every device transmitting traffic through the router regardless if they get an IP address from the router or not. Please fix this ASAP