EAP120 - unable to apply 5GHz
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP120 - unable to apply 5GHz
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
Got two EAP120's running in our new downstairs office. I have setup the WLAN group for the 5GHz but when I attempt to apply this to the AP's by clicking "5GHz" under WLANS, nothing is dropping down (such as the drop-down to select the WLAN group, and the name). Tried restarting the AP's, and forgot then re-registered an AP to see if it pulled the settings - still getting nothing when I click on any 5GHz options for the APs.
Any ideas? Getting a lot of 2.4GHz interference down there, so getting the 5GHz running would be a massive bonus
Hardware Version :
Firmware Version :
ISP :
Hi,
Got two EAP120's running in our new downstairs office. I have setup the WLAN group for the 5GHz but when I attempt to apply this to the AP's by clicking "5GHz" under WLANS, nothing is dropping down (such as the drop-down to select the WLAN group, and the name). Tried restarting the AP's, and forgot then re-registered an AP to see if it pulled the settings - still getting nothing when I click on any 5GHz options for the APs.
Any ideas? Getting a lot of 2.4GHz interference down there, so getting the 5GHz running would be a massive bonus
