Business Community > Routers > Tunel IPSEC with 2 TL-ER6120
< Routers

Tunel IPSEC with 2 TL-ER6120

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tunel IPSEC with 2 TL-ER6120

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tunel IPSEC with 2 TL-ER6120
Tunel IPSEC with 2 TL-ER6120
2017-07-28 14:39:21 - last edited 2021-08-21 06:14:01
Model :

Hardware Version :

Firmware Version :

ISP :

I try to connect two TP-Link TL-ER6120 through an IPSEC tunnel. I followed the steps in the manual, but the tunnel does not rise.

I have seen in the forum an article on creating a tunnel between a TL-ER6120 and a TL-R600VPN.
I followed the steps and I can not get the tunnel to connect.

Can somebody help me?
  0      
 
  0      
 
#1
Options
3 Reply
Re:Tunel IPSEC with 2 TL-ER6120
2017-08-24 18:04:14 - last edited 2021-08-21 06:14:01
Is there any other NAT device before the ER6120? If so, you have to do other setting on them.
If not, you can put the setting screenshots here, I can try to help you find the problem.
  0  
  0  
#2
Options
Re:Tunel IPSEC with 2 TL-ER6120
2017-08-25 13:23:00 - last edited 2021-08-21 06:14:01
Behind each tp-link I have an operator router.
  0  
  0  
#3
Options
Re:Tunel IPSEC with 2 TL-ER6120
2017-08-25 17:57:22 - last edited 2021-08-21 06:14:01

rcolomina wrote

Behind each tp-link I have an operator router.

Just need to make sure the parameter for each side are opposite. You can post the configuration screenshot here. I can try help.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 729

Replies: 3

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.