EAP320 not giving IP to client
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP320 not giving IP to client
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I have installed 2 EAP320 with the controller and I got a weird issue with them.
Randomly, they will not hand IP adresse to client. Client are connecting successfully but show the IP 0.0.0.0
I have set the band to 20Mhz, tried IP isolation and check every parameter I could find on the controller.
Everything else on the network is working properly and are getting IP from the DHCP as normal. DHCP scope is good and I have half the scope available.
AP were initially at v.1.0.0
I have already upgrade them to latest firmware: 1.1.2 20170725
Controller is at 2.4.8
The issue happen with no constant, happen on both AP and in both 2,4&5Ghz.
Wifi is set on WPA2-psk, AES.
No access control.
This is a fresh install.
Any idea how to fix this?
Hardware Version :
Firmware Version :
ISP :
Hello,
I have installed 2 EAP320 with the controller and I got a weird issue with them.
Randomly, they will not hand IP adresse to client. Client are connecting successfully but show the IP 0.0.0.0
I have set the band to 20Mhz, tried IP isolation and check every parameter I could find on the controller.
Everything else on the network is working properly and are getting IP from the DHCP as normal. DHCP scope is good and I have half the scope available.
AP were initially at v.1.0.0
I have already upgrade them to latest firmware: 1.1.2 20170725
Controller is at 2.4.8
The issue happen with no constant, happen on both AP and in both 2,4&5Ghz.
Wifi is set on WPA2-psk, AES.
No access control.
This is a fresh install.
Any idea how to fix this?
