TP-LINK TL-SF1005D not working after a power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-LINK TL-SF1005D not working after a power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-LINK TL-SF1005D not working after a power failure
TP-LINK TL-SF1005D not working after a power failure
2017-12-12 06:42:10
Model :

Hardware Version :

Firmware Version :

ISP :

After an unexpected power failure one of my little TP-LINK TL-SF1005D unmanaged network switches is no longer recognised by the router. It's showing as a dead port.

Have verified the port is OK on the router side.

The unit has power and all green leds are blinking slow, regular. I've tried restarting both router and switch.

It is bricked? Is there a way to reset it?
  0      
  0      
#1
Options
2 Reply
Re:TP-LINK TL-SF1005D not working after a power failure
2017-12-14 13:32:55
It's just a unmanaged one, plug and play device. Can't reset it. How about restart it again?
  0  
  0  
#2
Options
Re:TP-LINK TL-SF1005D not working after a power failure
2017-12-15 17:49:31
Tried that. It's also only £10 for a new one and this was 3-4 years old so have ordered a new one.(I guess it's possible that a fault in the unit caused the power to trip out, and not the other way around).
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 5427

Replies: 2

Related Articles