Route specific Lan IPs to specific wan on ER6020 V2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Route specific Lan IPs to specific wan on ER6020 V2
Model :
Hardware Version :
Firmware Version :
ISP :
Wan 1: Static IP
Wan 2 : Dynamic IP
Web surfing works fine with both ways connected
Each device in the premise has a static assigned lan IP and is reachable from the LAN through there IP address.
I have created several virtual servers with specific ports assign to each of them, all are assigned to Wan1. When only Wan 1 is connected I can remotely reach these web servers, when Wan 1 and Wan 2 are both connected it becomes impossible to remotely reach Web servers or so slow that it is unusable.
Can someone help ?
Hardware Version :
Firmware Version :
ISP :
Wan 1: Static IP
Wan 2 : Dynamic IP
Web surfing works fine with both ways connected
Each device in the premise has a static assigned lan IP and is reachable from the LAN through there IP address.
I have created several virtual servers with specific ports assign to each of them, all are assigned to Wan1. When only Wan 1 is connected I can remotely reach these web servers, when Wan 1 and Wan 2 are both connected it becomes impossible to remotely reach Web servers or so slow that it is unusable.
Can someone help ?
