Business Community > All Threads > CPE510 AP Disable DFS
< All Threads

CPE510 AP Disable DFS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 AP Disable DFS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 AP Disable DFS
CPE510 AP Disable DFS
2018-11-16 10:47:48 - last edited 2018-11-22 01:15:00

Hi,

 

I've got a really simple setup. One side of a canal is a BT business fibre router/firewall, a CPE510 in AP mode and a laptop for troubleshooting. The other side of the canal is a ASUS 4G-AC55U in 'media bridge' mode with a NetScreen firewall behind it then the user network behind that.

 

Originally the 'Channel/Frequency' was set to auto. The connection would work for a couple of days and then the ASUS couldnt find the SSID. I did a bit of research and a spectrum analysis and if I set the CPE510 to Channel/Frequency 104 / 5520MHz the connection works perfectly.

 

However for some reason (assuming DFS) the connection will drop and when I check the CPE510 the status page shows the Channel/Frequency is 136. For some reason the ASUS cant 'see' this channel. If i set the CPE510 back to 104 again it works perfectly.

 

Is there a way that the CPE510 can be forced to Channel/Frequency 104? Thanks.

 

 

Regards,

Paul. 

 

 

 

  0      
 
  0      
 
#1
Options
3 Reply
Re: CPE510 AP Disable DFS
2018-11-16 12:51:39 - last edited 2018-12-28 01:52:07

PaulK wrote

Is there a way that the CPE510 can be forced to Channel/Frequency 104? Thanks.

 

If DFS is a legal requirement in your country, then no (in most countries, DFS is a legal requirement). Radars such as weather, military and commercial radars have priority and WiFi equipment is required to leave the channel as soon as other radars are detected.

 

Just replace the Asus by another CPE510 to solve this problem.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:Re: CPE510 AP Disable DFS
2018-11-16 15:48:03

 

Thanks for the response. Is there a non-directional option?

 

 

 

  0  
  0  
#3
Options
Re: CPE510 AP Disable DFS
2018-11-17 11:12:17

PaulK wrote

 

Thanks for the response. Is there a non-directional option?

 

Do you mean the antenna radiation pattern? No, there are no omnidirectional antennas for the CPE510, it has built-in directional antennas.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 3405

Replies: 3

Related Articles
CPE510 does not show DFS Channels
719 0
CPE510 doesn't support DFS channels
1180 0
CPE510 dropping connection constantly - is it DFS?
2340 0
CPE510 DFS and extended event log
1452 0
CPE510 : AP as well as Bridge
487 0
(CPE510 AP) to (CPE510 Client)
1412 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.