Unable to access CCTV Decoder from client side

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to access CCTV Decoder from client side

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to access CCTV Decoder from client side
Unable to access CCTV Decoder from client side
2019-04-11 04:46:01 - last edited 2019-04-11 07:19:38
Model: CPE210  
Hardware Version: V3
Firmware Version:

Hi,

 

I need help on my setup as follow;

 

I have configured like this:

 

Router (GW 192.168.87.1/24) -> CPE210 (Access Point mode, IP: 192.168.87.50) -)))- CPE210 (Client Mode, IP: 192.168.87.55) -> CCTV Decoder (IP: 192.168.87.45).

 

My problem is, I cannot even ping all these IP from other subnet in my LAN, eg; from 192.168.86.0/24. My main priority is to access that CCTV Decoder. Please advice what is the correct way for me to implement this?

 

Thank you for your help.

  0      
  0      
#1
Options
1 Reply
Re:Unable to access CCTV Decoder from client side
2019-04-14 20:08:55 - last edited 2019-04-14 20:09:28

mevalier wrote

 

My problem is, I cannot even ping all these IP from other subnet in my LAN, eg; from 192.168.86.0/24. My main priority is to access that CCTV Decoder. Please advice what is the correct way for me to implement this?

 

You need to set up a network route into the 192.168.87/24 network in your 192.168.86/24 LAN and vice versa. Just add static routes on the router(s). 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 959

Replies: 1

Related Articles