TL-ER5120 Policy routing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-ER5120 Policy routing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-ER5120 Policy routing
TL-ER5120 Policy routing
2012-12-20 08:07:06 - last edited 2021-08-21 03:10:35
Region : Canada

Model : TL-ER5120

Hardware Version : V1

Firmware Version :

ISP :


I'm trying to setup Policy Routing, specific IP address will always go to WAN2 etc., I have WAN1 as primary and WAN2 as backup. I set this up but it is not working:



  0      
  0      
#1
Options
4 Reply
Re:TL-ER5120 Policy routing
2012-12-21 10:45:08 - last edited 2021-08-21 03:10:35
I think the main problem is because WAN 2 has been set up as backup. with the backup settings, WAN 2 won't function at all if WAN 1 is still working.
  0  
  0  
#2
Options
Re:TL-ER5120 Policy routing
2013-01-09 21:20:59 - last edited 2021-08-21 03:10:35
Try Removing, Any entry in Link Backup. DOnt do this "WAN1 as primary and WAN2 as backup."
  0  
  0  
#3
Options
Re:TL-ER5120 Policy routing
2013-02-21 01:59:38 - last edited 2021-08-21 03:10:35
Hey, I'm having similar problems here, with 4 WANs working (none of them is a backup).

I want a specific IP range to be redirected through WAN4 (and never use WAN 1, 2 or 3).

I added the IP to Policy Routing, specified All Protocolos and Always but it doesn't work, the router keeps assigning me to all the wans possible. I tried either enabling or disabling the bandwidht based balance, but no luck, policy routing is always ignored.

Screenshots:
http://i.imgur.com/5nE1u6I.png
http://i.imgur.com/hbmClkR.png

I really need a hand here, my router is ignoring me.
  0  
  0  
#4
Options
Re:TL-ER5120 Policy routing
2013-02-27 01:26:54 - last edited 2021-08-21 03:10:35
[QUOTE=masterl1nk;6511]Hey, I'm having similar problems here, with 4 WANs working (none of them is a backup).

I want a specific IP range to be redirected through WAN4 (and never use WAN 1, 2 or 3).

I added the IP to Policy Routing, specified All Protocolos and Always but it doesn't work, the router keeps assigning me to all the wans possible. I tried either enabling or disabling the bandwidht based balance, but no luck, policy routing is always ignored.

Screenshots:
http://i.imgur.com/5nE1u6I.png
http://i.imgur.com/hbmClkR.png


It works on me, I just enable all wan port in Enable Bandwidht Base.

Yes it works on me on LAN Source IP address. but my problem if LAN IP address to Destination WAN Port with Specific Remote IP address(Like Youtube) some Request wont pass to my specific WAN they still can go to other WAN port.

My firmware is latest version available.

They need to fix this problems
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1535

Replies: 4

Related Articles