TL-R470T+ for Fail Over and Minimum Bandwitdh
TL-R470T+ for Fail Over and Minimum Bandwitdh
Hi...I am using TL-R470T+ for Failover and combine bandwitdh from Two WAN.
But it seems neither of the function works.
Both my modem works well if were used alone.
My setup:
WAN 1 as Primary, ISP 4G Modem, metered connection, if the usage hit the limit, internet cannot connect at all, browser shows no connection.
WAN 2 as Backup, ISP 4G Modem.
CURRENT SETTING:
Status >> Traffic Statistics shows WAN 1 (Link Up) and WAN 2 (Link Down)
Network >> WAN 1 and WAN 2
Network >> WAN 1 has dynamic ip with certain ip adress and connection status "connected"
Network >> WAN 2 has dynamic ip with ip adress 0.0.0.0 and connection status "disconnected"
Transmission >> Load Balancing is enable
Transmission >> Load Balancing >> Link backup...WAN 1 as primary, if fail use WAN 2
Transmission >> Load Balancing >> Online Detection all use auto, but WAN 1 shows ONline, but WAN 2 shows OFFline
Question:
1. How can I manage the Fail Over properly.
What happened was WAN 1 had reach metered limit, it cannot switch to WAN 2.
WAN 2 can only function if I shutdown/disconnect WAN 1 (primary)
2. How to set WAN 2 (backup) support WAN 1 (primary) if the bandwitdh do not reach the minimum limit?
Lets say I wish to have minimum 10 Mbps, If WAN 1 (primary) is slow, then WAN 2 come to help.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Well...please tell what is your configuration and what you expect from this device.
Mine use load balance for 2 modem (4G). Those modem is connected through special 4G antenna wire to catch better outdoor signal.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 9490
Replies: 11
Voters 0
No one has voted for it yet.