Business Community > All Threads > Beamforming option on EAP245 V3 using OC200
< All Threads

Beamforming option on EAP245 V3 using OC200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Beamforming option on EAP245 V3 using OC200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Beamforming option on EAP245 V3 using OC200
Beamforming option on EAP245 V3 using OC200
2019-12-18 21:29:03
Model: EAP245  
Hardware Version: V3
Firmware Version:

Trying to locate where is the beamforming option under settings and if it's auto enabled/on by default then the tp-link document pointing towards it. Under US-EAP245 specs mentioned that it support that option but I just can't seems to locate it. Using latest version on the APs and also on the controller. Thanks!

  0      
 
  0      
 
#1
Options
1 Reply
Re:Beamforming option on EAP245 V3 using OC200
2019-12-19 01:41:25

@wifiprosz, antenna beamforming is the way MU-MIMO is implemented on EAP225/EAP245. Thus, you can't enable it and there is no need to disable it either. It's a characteristic defined in 802.11ac, so if you select AC mode, you will get antenna beamforming.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 2634

Replies: 1

Related Articles
EAP245 v3 - roaming without controller / beamforming
10453 0
EAP245 V3 not showing stats with OC200 controller version 3.2.14
1178 0
EAP245 V3 from Amazon
1017 0
EAP245(V1) with OC200(V2)
880 0
EAP245 V3 TCPDUMP inquiry
1017 0
EAP245 v3 :: 5GHz channels
2429 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.