Not getting expected speeds
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm having trouble getting expected speeds.
Configuration:
WAN1 = 1000Mbps/50Mbps cable connection
WAN2 = 40Mbps/3Mbps DSL connection
Both lines have been tested to provide expected speeds when connected directly or through a Netgear R7000 router. When I remove the Netgear from the equation and connect everything to the TL-R600VPN, my speeds burst to 400Mbps but come down to about 200Mbps.
Port status is showing all connections with a 1000Mbps full-duplex link.
Transmission --> Load Balancing
Load balancing is enabled.
Enable Application Optimized Routing is enabled.
Transmission --> Load Balancing --> Link Backup
Not configured.
Transmission --> Routing --> Policy Routing
One IP range configured to use WAN2 for lower bandwidth traffic.
Other IP range configured to use WAN1 for higher bandwidth traffic.
Am I missing a configuration somewhere or do I have something improperly configured?
