Business Community > All Threads > OC200 Eth2 Configuration
< All Threads

OC200 Eth2 Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200 Eth2 Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 Eth2 Configuration
OC200 Eth2 Configuration
2020-06-29 14:50:44 - last edited 2020-07-01 05:35:37
Model: OC200  
Hardware Version: V1
Firmware Version: 1.2.3 Build 20200430 Rel.52621

Hi All,

 

does anyone have an experience with assigning a different IP Address to the OC200 Eth2 port?

 

We've deployed a TP-Link guest WiFi solution for a client which is running along side an exisiting UniFi setup. Ideally I would like the OC200 to access the internet from Eth1 and talk to the access points from Eth2, both ports would be seperated by VLans.

 

So far when I try to use the Management Vlan option, the OC200 dissapears and is not accessable at all, I've had to restore it to factory defaults twice just to disable this option. 

 

Thanks

 

Mike

  0      
 
  0      
 
#1
Options
1 Reply
Re:OC200 Eth2 Configuration
2020-06-29 22:00:28 - last edited 2020-07-01 05:35:37

 

Mwebb_Sureline wrote

does anyone have an experience with assigning a different IP Address to the OC200 Eth2 port?

 

The eth2 interface is bridged with eth1, so it shares the same IP as eth1 does (think of both ports being two ports of a switch).

 

So far when I try to use the Management Vlan option, the OC200 dissapears and is not accessable at all, I've had to restore it to factory defaults twice just to disable this option.

 

Traffic to/from an OC200 is always untagged. If you set the »Management VLAN«, this affects only EAPs, but not OC200.

 

See this HowTo (skip to »Method 2«) on how to set up a guest network using VLANs to isolate it from the local network.

 

BTW: The forum for Omada Controller / Omada EAPs is here. This one is for the SDN Cloud Controller.

jonas, please can you move the thread to the Business WiFi forum? Thanks!

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 3079

Replies: 1

Related Articles
ETH2 2 port on OC200: How to configure
557 0
Cant access OC200 configuration
174 0
Configure DHCP Relay Omada OC200
1105 0
What is the purpose of Eth2 on the OC200?
2364 0
Omada OC200 Config: Is there a way to bookmark pages?
444 0
OC200 Auto Backup proper config guide
7258 1
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.