CPE510 Poe not working on Access Point side now

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 Poe not working on Access Point side now

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 Poe not working on Access Point side now
CPE510 Poe not working on Access Point side now
2020-09-30 23:02:21
Model: CPE510  
Hardware Version:
Firmware Version:

Set everything up 2 days ago. Has been working great. Had Poe on a temporary mount at cousins house behind us and mount fell down today. Cat6 wire was still connected and no damage but LAN light blinks, shows full signal and then just power light show. It just keeps repeating this pattern. I unplugged cat 6 cable for a few seconds from Poe and no change. 
 

Any help is greatly appreciated!

  0      
  0      
#1
Options
1 Reply
Re:CPE510 Poe not working on Access Point side now
2020-10-04 11:17:08

@Bobert540 

 

Cat6 wire was still connected and no damage but LAN light blinks, shows full signal and then just power light show. It just keeps repeating this pattern. I unplugged cat 6 cable for a few seconds from Poe and no change. 

 

It seems like the CPE510 is auto-reboot/reset, you may test the non-working CPE510 with another PoE Adapter from another working CPE510, if it works after replacing the PoE adapter, then the PoE adapter may have an issue, test the non-working PoE adapter with the working CPE510 to confirm it. Otherwise, it's likely that the CPE510 has been defective by the accident.

  0  
  0  
#2
Options