add ipsec direct entry with existing l2tp/ipsec

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

add ipsec direct entry with existing l2tp/ipsec

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
add ipsec direct entry with existing l2tp/ipsec
add ipsec direct entry with existing l2tp/ipsec
2021-01-22 11:00:06 - last edited 2021-04-18 09:58:30
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version:

Hello,

 

I've a TL-R600VPN configured to accept L2TP connections from different sites or users, all with dynamic address.
Because of L2TP config, I've in VPN/IPsec/IPsec Policy an entry X_l2tp_server1.

 

I'd like to add, for another client, a direct connection IPsec, also with a dynamic address (means 0.0.0.0 in gateway field).

When I try to do that, OK (always) give me: For an IPsec policy with the same IP address at both ends, the parameters in Phase-1 should be kept the same.

I can understand that but what should I set in the setup? I certainly can adjust the new entry but to what? What is the full config of X_l2tp_server1 autogenerated entry?

 

Regards,

JM

  5      
  5      
#1
Options

Information

Helpful: 5

Views: 962

Replies: 0

Related Articles