How may I get config ER-7206 to Listen for only 1 ip?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How may I get config ER-7206 to Listen for only 1 ip?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

JLKramer

2021-05-08 22:53:34 - last edited 2021-05-10 18:04:12

Posts: 2

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2021-05-08

How may I get config ER-7206 to Listen for only 1 ip?

2021-05-08 22:53:34 - last edited 2021-05-10 18:04:12

Model: TP-Link Routers

Hardware Version: V1

Firmware Version: V1.01

I am trying to figure out how to set up a TP-ER7602 to listen for only 1 ip where I have it and another router coming off the same cablebox. My ideal configuation is below, but I can't seem to get the 7206 to only listen for a single IP: The problem is that it won't let me set teh Network Mask to 255.255.255.254 which seems to be right for a single IP.

ALL help and comments will be appreciated!

Jonathan Kramer

1 Accepted Solution

MR.S

LV5

2021-05-09 15:15:11 - last edited 2021-05-10 18:04:12

Posts: 2129

Helpful: 770

Solutions: 271

Stories: 0

Registered: 2018-08-17

Re:How may I get config ER-7206 to Listen for only 1 ip?-Solution

2021-05-09 15:15:11 - last edited 2021-05-10 18:04:12

you can not use 255.255.255.254 on a router. you have to use same subnetmask as your cable modem, This is problaby 255.255.255.248 so your ipconfig will be ip x.x.x.123 mask 255.255.255.248 gateway x.x.x.120

Information

Helpful: 0

Replies: 2

How may I get config ER-7206 to Listen for only 1 ip?

How may I get config ER-7206 to Listen for only 1 ip?

Information

Voters 0

Tags