Switchport Config for EAPs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello everyone, I am running my controller on an RPi4. Which works ok but I am having issues with the EAP660. I have the 8 port 2.5Gb PoE switch which I am managing by CLI and the switches WebGUI. I am trying to config the port correct in order to give it an IP on one specific VLAN but still managed on the Omada Controller. How would I go about doing this with the switches GUI or CLI?
I have vlan 201-206 on the switch, and 205 is the vlan I want the AP getting an IP from, my controller is on vlan 206 and the switches native vlan is 202. I keep getting an IP on the AP from 202 and when I change the management vlan on the AP within the controller to 205, I just lose access to it overall and need to reset it.
How do I properly set up the port to trunk all the vlans over and get an IP from the 205 vlan?
