EAP Factory reset not (quite) working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My Omada controller died a while ago, and this AP has been unused for a while. I now want to repurpose it for my daughter, who is moving to a campus room with a private internet connection...
I've tried to reset it with the pinhole reset button, and it blinked green twice, red twice, green twice, red twice and then seemed to reboot a few times in a row...
When I now scan it, only port 22 is open, and ssh-ing in to it with admin/admin does seem to get accepted (other passwords get a 'Permission denied' error, so that seems to be quite correct), but then I get an error:
PTY allocation request failed on channel 0
shell request failed on channel 0
The scan results show:
# nmap 10.*.*.179
Starting Nmap 7.60 ( https://nmap.org ) at 2021-12-02 15:38 CET
Nmap scan report for 10.*.*.179
Host is up (0.0074s latency).
Not shown: 999 closed ports
PORT STATE SERVICE
22/tcp open ssh
MAC Address: 50:C7:BF:CA:DD:7A (Tp-link Technologies)
Nmap done: 1 IP address (1 host up) scanned in 10.18 seconds
What else can I try to get this device back up and running as a standalone AP?
PS: It still gets an IP address from the DHCP server as well, so no '192.168.0.254' address or something similar!
