CPE510 Point to Multi Point ip camera to nvr

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 Point to Multi Point ip camera to nvr

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 Point to Multi Point ip camera to nvr
CPE510 Point to Multi Point ip camera to nvr
2022-02-04 22:39:01

Hi I'm try to configure ptmp cpe510 for ip cameras. What is the best way to set them up. I have one ap going to two clients. 

  0      
  0      
#1
Options
1 Reply
Re:CPE510 Point to Multi Point ip camera to nvr
2022-02-08 08:18:37

Dear @Ekelly ,

 

Ekelly wrote

Hi I'm try to configure ptmp cpe510 for ip cameras. What is the best way to set them up. I have one ap going to two clients. 

 

All you need to do is to configure the appropriate operation mode for all CPEs in one place and then deploy them to the appropriate target point.

Please note adjust the angle of the CPEs and align the antennas.

 

This article will help you learn more details:

https://www.tp-link.com/us/configuration-guides/common-applications-for-pharos-products/?configurationId=22033 (Point to Point)


Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 776

Replies: 1

Related Articles