Home

Forums

Stories

Knowledge Base

Business Community > All Threads > TL-SG2008p LAG LACP no members after adding

< All Threads

TL-SG2008p LAG LACP no members after adding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG2008p LAG LACP no members after adding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

devzer0

2022-02-25 06:09:31 - last edited 2022-03-01 10:40:50

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-24

TL-SG2008p LAG LACP no members after adding

2022-02-25 06:09:31 - last edited 2022-03-01 10:40:50

Model: SG2008P

Hardware Version: V1

Firmware Version: 1.0.2 Build 20210806 Rel.55686

Hello friends.

I have strange issue with this device. I try to make LACP on 1/0/7-8 using web-interface. And i find few official instructions about that.

So everywhere same steps:

L2 Features - LAG - LACP Config
Checkbox enable on few ports, Status - Enabled, Group ID same for marked, Port Priority, Mode

After all manipulations go back to LAG Table and didn't see members on my LAG. And LACP didn't work

It is clean device right after reset

f8ebcc6dc3a2440786ed9f544c01a555

1 Accepted Solution

Hank21

2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:TL-SG2008p LAG LACP no members after adding-Solution

2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

@devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/

You may check LACP settings on the another side switch/device, and then have Ethernet cable connected.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

1 Reply

Hank21

2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:TL-SG2008p LAG LACP no members after adding-Solution

2022-03-01 07:58:55 - last edited 2022-03-01 10:40:50

@devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/

You may check LACP settings on the another side switch/device, and then have Ethernet cable connected.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Information

Helpful: 0

Replies: 1

TL-SG2008p LAG LACP no members after adding

TL-SG2008p LAG LACP no members after adding

Information

Voters 0

Tags