Hi. Struggling a bit with this one.

I have 2 EAP660HDs, connected to a switch with 2.5GbE. Using a self hosted speed test on a server connected to the network via 10GbE.

Clients are laptops equipped with Intel ax200 cards. Firmware is at the latest available.

For sanity checking, using a wired device on a 2.5GbE LAN port, I can achieve 2454.5Mbps Rx 2471.4Mbps Tx on the speedtest.

However, with ax clients, I can only achieve 200 - 400mbps Rx 700 - 800Mbps Tx

I've been trying numerous configurations. With one of the APs powered off to cut down on interference and the SSID changed so that only one device is connected to it.

So far, the best results I can get are with using 80Mhz channel width, WMM, Unscheduled Power Save Delivery & OFDMA enable, everything else off. I've gone through every channel available. During testing, the ax client & EAP660HD where within 5 foot of each other.

I'm in a very remote area so there's no interference from other networks.

Any tips? I'd like to be able to achieve similar speeds Rx as I do Tx.