Home

Forums

Stories

Knowledge Base

Business Community > All Threads > Signal Drops Frequently on CPE610, CPE510

< All Threads

Signal Drops Frequently on CPE610, CPE510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Signal Drops Frequently on CPE610, CPE510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

zoie

2022-04-06 19:50:03 - last edited 2022-04-07 21:12:23

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-04

Signal Drops Frequently on CPE610, CPE510

2022-04-06 19:50:03 - last edited 2022-04-07 21:12:23

Model: CPE610

Hardware Version: V1

Firmware Version: 2.2.1 Build 20200516 Rel. 40358 (0000)

I'm facing an issue with my current setup of CPE610 as a Transmitter (AP) and CPE610 & CPE510 as Receivers (Client). All 3 devices are updated to the latest firmware and I have tried setting different frequencies & settings with all options tried ON/OFF.

When the CPE's boot up after a fresh hard restart, The CPE510 is negotiated at around 240MBPS and CPE610 is negotiated at around 30-60MBPS due to different distances. After a day or two the CPE's negotiated rate drops to almost zero and needs to be restarted. I have set Ping Watchdog to overcome this issue but still it's no help.

CPE610 (AP) Settings

Transmit CCQ: 83

CPE610 (Client) Settings)

Signal Strength (Horizontal/Vertical): -89/-64 dBm

Noise Strength: -97dBm

SNR: 33dB

Transmit CCQ: 87

CPE510 (Client) Settings

Signal Strength (Horizontal/Vertical): -57/-53 dBm

Noise Strength: -94dBm

SNR: 43dB

Transmit CCQ: 95

1 Accepted Solution

Hank21

2022-04-07 07:09:45 - last edited 2022-04-07 21:10:46

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Signal Drops Frequently on CPE610, CPE510-Solution

2022-04-07 07:09:45 - last edited 2022-04-07 21:10:46

@zoie

Hi. While you set the channel width to auto, it is normal that your speed will fluctuate between 20MHz and 40MHz. You can fix that to 40MHz for a test.

From the network diagram you described, it is Point to Multiple Points instead of a traditional P2P. I think it is would be better to use MAXtream since that is designed for P2MP. Turn that on and check again.

For optimization, you can also analyze your radio frequency in your environment and find the less interfered one and use that to transmit.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Information

Helpful: 0

Replies: 2

Signal Drops Frequently on CPE610, CPE510

Signal Drops Frequently on CPE610, CPE510

Information

Voters 0

Tags